Porodo high-speed 4G router enjoys ultra-speed internet connectivity up to 300 Mbps using your standard sim card. This new 4G sim-supported router will help you to connect multiple devices without any specific devices with internet connectivity. Once you connected a 4G sim card the device will access the internet and shares the network with wired and Wi-Fi users through NAT. 

Use a complete pack to speed up your internet speed with 2*WIFI & 2*LTE you can also insert your SIM and use your SIM's internet as well, a high-speed 4G router 300Mbps Wi-Fi & 4G LTE will make you satisfied with your speed. You can easily install this router with the available data pack on your sim card. Therefore you don't need any extra wiring the connection risk to connect your wifi modem with your devices. 

Porodo 4G router can be functional in multiple modes including 4G mode, Routing mode, Automatic acquisition, PPPoE dialing, and Static IP. 

User manual and installation guidelines are available in the attached document. 

Default Wi-Fi password is 9876543210

4G Mode: The device accesses the Internet through 4G mode, and shares the network to wired and Wi-Fi users through NAT conversion technology. The device WAN physical interface is converted into LAN interface mode.

Routing Mode: The device accesses the Internet through wired mode, and shares the network to wired and Wi-Fi users through NAT conversion technology. The device 4G function will be stopped. There are three ways to access the network through wire: automatic acquisition, PPPoE dialing, Static IP (as shown in Figure 1 0), please consult your broadband provider for Internet access information.

Automatic Acquisition: Obtain IP address information from the superior device, you can access the Internet without setting up the Internet access information. Usually, the computer wired access can be accessed without setting.

PPPoE Dialing: The device needs to dial the fixed account and password to access the Internet. The account and password can be consulted by the broadband service provider to obtain relevant information (as shown in Figure I l

Static 'P': The device needs to manually fill in the IP address, subnet mask, gateway and DNS information to access the Internet. For this information, please consult the gateway administrator or broadband service provider for relevant information (as shown in Figure 12).

AP mode: When the device is wired to the Internet, NAT function will be stopped, the device's WAN physical interface will be converted into LAN interface mode, and the network will be shared to the wired and Wi-Fi users. Network services and information will be provided by the upper device, and the device will only provide the service of converting the wired to Wi-Fi.

Routing Mode: If the device needs to be set to "Routing Mode" or "AP Mode", please refer to the above instructions and follow the instructions of the operation guide. After the setup is complete, the device will restart, and the mobile phone searches for a new Wi-Fi name signal, enters the password to access the Wi-Fi.